Customization: | Available |
---|---|
Customized: | Non-Customized |
Product Category: | ECG |
Suppliers with verified business licenses
Audited by an independent third-party inspection agency
Philips ECG 5-Lead Snaps Cable is used to measure ECG for patients. To be precise, it does not directly act on the patient's body, but it is used indirectly by adding a pads at the front electrode of the cable. It is used in conjunction with the Philips IntelliVue MX40 Patient Monitor, which means that its plug end can be connected to the Philips MX40 patient monitor, and the other end is connected to the patient, and then the measured ECG data of the patient will be displayed on the Philips MX40 patient monitor on the display screen for medical staff to refer to. But it may not be compatible with other monitor devices, so you need to pay attention to this before using it. It is an ECG 5-Lead Snaps Cable that can be used by both adult patients and pediatric patients. It is a high-quality cable suitable for various medical care environments.
Product Category | ECG |
Product Type | Telemetry Lead Set |
Use | Multi-Patient Use |
Patient Application | Child; Adult |
Number of Leads | 5 |
Electrode Attachment Method | Snap |
Lead Set Length | 85 cm (33.5") |
Shielded | Yes |
Color Coding | AAMI |
For clinical medicine, it is very important to select the appropriate lead showing the largest amplitude and the cleanest signal so that the monitor can accurately detect the QRS complex and R wave, especially the R wave. So some rules should be followed when choosing, the first is that the QRS complex should be tall and narrow (recommended amplitude > 0.5 mV). This is followed by an R wave that should be above or below baseline (but not biphasic), then a P wave that should be less than (1/5) the R wave height, and finally a T wave that should be less than (1/3) the R wave height. In this way, it is almost possible to choose a suitable lead. However, to prevent detection of P waves or baseline noise as QRS complexes, the minimum detection level of QRS complexes was set at 0.15 mV. This is About Lead Selection, which must be considered before performing ECG measurements on patients.
Thank you for your time. If you are interest in Philips MX40 Patient Monitor Cable ECG 5-Lead Snaps AAMI 989803171841, Please kindly contact me.